Operation Procedure

1. Disconnect the load and pulse the unit at approximately 60hz for approximately 5 seconds until the dc voltage across the capacitor reads 40-50 volts.

2. Connect the load.

3. Pulse the device at approx. 60 hz for approx. 5 seconds every 30+ minutes. There is no need to disconnect the load during this re-charge. Motor rpm will drop noticeably during this time then immediately return to normal.

4. Be advised that a vom across the charge cap will slightly increase the time required to reach the desired voltage at pulse.

5. Voltage indicated across the cap was kept in the 20-50v range, although a dissipation to under 20v, but above supply, may work as well or more efficiently.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment