Sweet VTA

This device appears to have manifested the same negative energy as the Adams motor.

'Negative energy is fully capable of lighting incandescent lights, running motors, and performing all of the functions of positive energy tested to date. When run in parallel with positive energy however, cancellation (annihilation) of opposing power types occurs. This has been fully tested in the laboratory.'

'The coils are very small diameter copper wire but are capable of producing in excess of 5 kilowatts of useful power; this in itself is a clear indicator that the type of electrical energy provided by the device is not conventional. The wire sizes employed by the device would not be capable of carrying such large currents without excessive heat gain, however, the triode's coils actually run cooler when loaded at 5 kW.'

The Space Energy Newsletter (1993), Vol. IV, I, also offered some fascinating insights

Floyd's experiments demonstrated that the VTA loses weight in proportion to the amount of generated "Negative Energy". This was carefully documented by Floyd on a kitchen scale. The machine weight was observed decreasing with increased load in a quite orderly fashion until a point was suddenly reached when Floyd heard an immense sound, as if he were at the center of a giant whirlwind but without actual air movement. The sound was heard by his wife Rose in another room of their apartment and was heard by others outside the apartment. The experience was very frightening and the experiment has not been repeated (These power levels perhaps took Sweet right up to the edge of ripping open a worm hole - as Tesla's equipment did in 1943, with the infamous and tragic 'Philadelphia experiment' - Ed).

One frustrating aspect of the VTA has been its failures, evidenced by the output voltage slowly decaying to zero over a few seconds or minutes. There also has been spontaneous instances of the voltage rising above 120 VRMS as observed by the increased lamp load bank brightness. The volt meters, ammeter, and power meter did not correlate with the brightness change except when the machine would the fail to produce any power.

The 20 gauge magnet wire in the output coils consisting of several hundred turns has significant DC resistance which is not correlated with the unvarying output terminal voltage at different loads. It is speculated that this energy does not travel within the copper wire or its passage through the copper wire does not generate a voltage drop - a most useful feature when transferring energy from one place to another.

Many times the VTA was normally left on powering a lamp load bank 24 hours a day. During a period of time when it appeared to be functioning properly all day long, Floyd got up at 3:00 AM to go to the bathroom. As he walked past the room where the VTA was located, he noticed that the lights appeared dim. He measured the voltage at 70 VRMS. Being tired at the moment, he returned to bed. The next morning when he rose, the voltage was back to the normal 120 VRMS and stayed there all day. The next night Floyd got up at 4:30 AM. The voltage was measured at 85 VRMS. Floyd returned to bed. The voltage was normal the entire next day.

The reliable conditioning of the magnets in a manner that assures long time operation is the Achilles heel of this device.

Some observers of the light emanating from ordinary 120 volt 100 watt incandescent bulbs powered by the VTA claim the light is different, softer, than normal incandescent light. The VTA magnets and coils when powering loads of over a kilowatt become cold and temperatures of 20 degrees Fahrenheit below ambient have been observed.

When the VTA output wires had been accidentally shortened, first an extremely brilliant flash occurred. When the wires involved were examined shortly afterward, they were found covered with frost.

Conventional instruments used to measure volts, amps, or watts appear to correlate machine output as coupled to loads, but only up to approximately 1 KW; above that value they may indicate zero or some other value not related to the known actual load. Floyd's attempts to use conventional electrical design formulas relating number of coil turns, amp turns on drive coils, and any other parameter to predict observed outputs have all resulted in failures with calculations. Empirical formulas based on actual tests have been documented.

Magnet size seems to be secondary to volume of the windings wire, diameter, input voltage and current.

Quality of oscillator is important- there should be no harmonic distortion i.e. pure sine wave output.

The VTA "likes" to always see a minimum load of 25 watts.

The effect is manifested at 9v and above (this agrees with my results - Ed).

Electrical shock to humans from the VTA may be more damaging than contact with a 120 VRMS 60 HZ conventional powerline voltage. Floyd has accidentally had VTA current pass from his thumb to his smallest finger. It appears to freeze the flesh and was extremely painful for at least two weeks. The mechanism by which negative energy makes copper conductors cold but will also heat light bulb filaments is not understood.

Alternative Energy

Alternative Energy

It seems like the efforts to find the best alternative energy sources are seriously being looked into by lots of countries including most US cities. One proof is the signing of the Kyoto Treaty. The main aim of the concerned group and individuals is to lessen the greenhouse gases and pollutants.

Get My Free Ebook

Post a comment