Update From Mr Adams

The cardinal mistake being made here is that most of these experimenters are concerned about PR losses! If you are seeking high/super performance with these powerful magnets, then discard all concerns in relation to Ohms Law, for in the Adams technologies Ohms Law becomes a non-entity. Instead of expecting results of a high order with stators of very low resistance, such as under 10ohms, increase the total series electrical resistance instead to 72ohms and instead of expecting spectacular results using these powerful magnets with only 12 - 24 volts, increase the voltage to a minimum of 120v. Upon having done this you must give attention to other important factors, i.e., stator to magnet air gap should be 1 - 1.25mm, impulse duty cycle should be 0.25 - 0.35, "mosfet" gate signal impulse 10 - 20v of good clean stable D.C. Upon initial experimental tests, I have always used batteries. Reduce the face area of stators to 75% of the magnet face.Now having said all this, choose your own method of signal switching, whether it be photo, hall, magnetic, reed or mechanical, etc.Upon fine tuning, and now having reached greatly increased power and performance, 'DOUBLE' the power supply voltage to 240v and you will have a machine in the "kilowatt" range, the exciting stage of your progress.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment