Data Points

To be able to redraw and save the plot, the incoming digital and analog data is stored in what are termed 'Data Points'. By default the number of Data Points stored is 500. This may be adjusted under the Configuration Window's Data tab. Changing the number of points will reset your plot. The amount of data points used is shown graphically in the lower left corner Figure C-2.

Figure C-2

Data Points Bar Graph

Once the data points are full, the plot will reset. Very large amounts of data points are NOT recommended (over 5000) as they will considerably slow the plot when it is refreshed.

To perform continuous plotting the option to 'Flush Old Data' may be enabled pressing F11. This will remove a percentage of the oldest data from the Data Points storage each time it fills to maximum.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment