Parts List Cont

Fuelless Engine

1- QTY 15 DIAMETER X 12 DEEP X NO LESS THAN 1 8 THICK STEEL OR WOOD DRUM. THE ONE WE USED FOR OUR PROTOTYPE WAS A WOOD DRUM FROM A LUDWIG DRUM SET. This prototype is designed to be scaled up or down. 14- Nuts and bolts to hold down magnets onto drum, about 1 4 x 2 1- 12 volt DC 60 to 100 amp generator for keeping up an inverter battery system or you can use a 10,000 watt 120 volt ac generator 1- 8 X 5 8 ALUMINUM PULLEY GRAINGERS WILL HAVE THEM OR A HARD WARE STORE. if you use a 5 8 pulley with...

Our hp DC Motor I For research purposes only

Part C The Rotor Shaft Sorry Photo needs to be updated. Wrong Commut'qtor see plans. Sorry Photo needs to be updated, Brushes are on wrong side, see plans. Silicon or J-B Weld to glue 2 magnets to shaft. Part D amp E Support Arms for Rotor Shaft Part M Brush Assembly Holding Bar, Steel Part R Transformer Electromagnet s you will need to take apart a transformer and 16 gauge or 18 copper coated wire, used in research for collecting electricity from electromagnet and as a magnet it self, This is...

Ricks DC Motor Generator

Bedini Motor Generator

This is a research device, Capacitor and diode ratings depend on the voltage input vs what size coil wire used and of winds. If you use a coil that is wound several thousands of times with number 38 or 36 copper coated wire, you are going to need to use voltages from 1000 to 3,500 vdc input. The back emf will be great. 38 wire is hair thin and hard to wind but it is the best to use for a PVC air core type magnet. 2000 - 3,500 vdc input for air cores 120 to 600 volts for iron cores. Switch...

Timing the Fuel less Engine

Fulless Engine

To get an idea of how a DC brush motor works, take apart any size DC motor and check it out. Study it carefully. Timing the Fuel less Engine 1,000 vdc is applied to the brush assembly, the brush assembly acts as an on and off switch for each set of magnets. The brush assembly can be made in many ways. The timing takes place in two places, the spark plug caps or the commutator brush collar assembly. You will only need one 1,000 vdc charging and firing system that is rated at 1 to 3 amps, the...

The Fuelless Engine Plans

Fuelless Engine Disk Motor

The outer case The stator housing Can be aluminum pipe. See aluminum salvage yards, industrial junk yards in your area. The size and horse power can be up to you. There are laser cutting companies that will cut metal or aluminum to any size or , shape you want and it is not that expensive. The rotor plates must be cut by a laser and pieced together or hand cut and balanced on a machine shop lathe machine. Use the illustrations below as a guide to give to your laser cutting company. Part 1 can...

Notice The center hole of this drawing is not centered do not photo copy some of these drawings are not in actual

Fuelless Engine Disk Motor

These are the front and back plates, you will need a Qty of 2. you will need to have them laser cut. you will also need to buy 2 1 pillow bearings for the center shaft to ride on. The Stator housing can be made of 1 4 aluminum, steel, PVC sewer pipe or wood. Aluminum is BEST our second prototype we used a 1 4 plexi housing, with aluminum block braces, the braces connected to the front and back plates, and there were 4 in all. this took the pressure off the plexi, to keep from breaking. 1 4...