Untuned State

out paying for thai-—explained elsewhere—refer paragraph 4 in section headed 'Losses in Electrical Machines'). Secondly, the attraction of the gravitational repulsion forces in the anti-gravity area (as illustrated in Drawing TO-GOO 1, Figure 2, at arrows A & B). Thirdly, from the repulsion pulse of the stator at point 'x°' (refer to pulse angle of Drawing TD-G001, Figure 1). Fourthly, the rotor is given a further pulse from the collapsing field (a few degrees from point 'x°' in Figure 1).

For maximum possible results from the 'Adams Advanced (Mark II) Motor', it is necessary to apply harmonic/resonance equations for the calculation of all parameters including speeds and frequency. With the foregoing parameters met, it is recommended to engage magnetic, or photo switching with its low loss, high cfficicncv properties. Drawing TD-G002, on the left, illustrates a positive 'untuned stale and, on the right of the same drawing, a 'tuned resonant stale', together with a graph showing relative polarity change with component dimension changes. The area within the lower circle of the system indicates both poles arc at north polarity (note the two curved arrows at each side of the magnet pole which depict the change that is/has taken place in the negative-time area).

It is possible to engineer the 'Adams Advanced (Mark II) PF.MCV in such a way that a machine of any desired efficiency may be constructed from 100% up to four figures and beyond.

The icrm 'efficiency' now bccomcs a matter to be addressed, which I have done in the section headed 'Free-Energy Devices and the Term 'Efficiency' and its Connotations'.

PERMANENT MAGNETS AND 'WORK1

Permanent magnets do not and can not 'do work'—as claimed by certain people.

It ¡s ihe. eiher/ujiiviiv forces which cause immense attraction and/or repulsion to take place between a permanent magnet and other magnetic material. It is these ether forces that, combining with the captive permanent magnet fields, harness the energy of gravity ether forces, so often erroneously referred to as 'work'— 'done by magnets' (refer to notes on Nikola Tesla at the end of this section).

The magnets in this situation are simply acting 'as a gate', making way to the ether for the collection/release of gravitational/ether energy. The permanent magnet is a component in the system, operating as a 'gating device', as explained elsewhere in my writings—the magnet does not generate or create power (refer to Drawing TD-G005).

If magnets were doing 'work', they would heat up! The contrary takes place in negative-time systems during operation: rotor magnets drop in temperature below ambient in the above-described environment. Subtracting the drop in temperature of the rotor magnets from any small rise (if any) in stator temperature, due to minuscule hysterisis, would cancel the difference. The deeper the condition of resonance in the system, the lower the temperature of the magnets and stator windings.

When magnets and stators are engineered into negative time, the rotor, upon eclipsing face-to-face with the stator poles, causes a state of negative energy/negative time in that area at that moment in time. Almost simultaneously there is, in addition, the vector zero stress due to the resonantly-tuned wave trains of the stator pole generated voltage with that of the pulse voltage wave, resulting in a near mirror image.

The negative time/negative energy area between rotor magnet and stator independently causes an increase of 100% magnetic radiation every time a pole of the rotor passes a stator.

In this negative time, gravitational force is reversed; so in negative time, gravity becomes a repulsion force, not an attraction force.

Saving Power, Saving The World

Saving Power, Saving The World

Get All The Support And Guidance You Need To Be A Success At Helping Save Power. This Book Is One Of The Most Valuable Resources In The World When It Comes To How To Use Renewable Energy As Your Alternative Power Suppliers.

Get My Free Ebook


Post a comment