Shock Charging System By Stefan Hartmann

I used a 12 Volts relay (not shown here) in selfrunning vibrator mode for mechanically toggling the S1 switch on and off with a frequency ofabout15to 20 Hz. Thefl tube was lit to about half its brightness and the battery did not discharge, but seemed to charge up a bit More and longertests are ' still needed I

Fluorescent tube 8 Watts

1N4007

selfrunning vibrator Relay switch secondary 220 Volts 240 Ohm

Battery__

12 Volts -

selfrunning vibrator Relay switch primary: 30 Volts 5.7 Ohm ! DC resis.

efficient spark gap driven fluorescent lamp driver version 1.1, idea based on Konzen's spark gap effects and Newman technology, battery recharching effect I released and tested on 21 st of June 2001 by Stefan Hartmann for www.overunity.com

secondary 220 Volts 240 Ohm primary: 30 Volts 5.7 Ohm ! DC resis.

Overunity Transformer

transformer

220 Volts to 30 Volts type 0.4 Amp ca. 5 Watts type used backwards

ELECTRICAL DIAGRAM

The Shock Charging System presented by Stefan Hartmann is classified as a CATEGORY 3A Over-Unity Device. The excess electrical energy appears in the secondary coil of the transformer during the demagnetization phase of a magnetization/ demagnetization cycle.

The magnetization phase of the cycle is initiated by closing switch S1. The fluroescent tube functions as current limiting resistor.

Solar Panel Basics

Solar Panel Basics

Global warming is a huge problem which will significantly affect every country in the world. Many people all over the world are trying to do whatever they can to help combat the effects of global warming. One of the ways that people can fight global warming is to reduce their dependence on non-renewable energy sources like oil and petroleum based products.

Get My Free Ebook


Post a comment